The SWELL Wakesurf Creator XL is designed for a small segment of boats that are Over 23ft with tons of ballast (more than 2,500lbs), for boats that are just at 23ft, or less than 23ft you will often see a worse wave than the SWELL Wakesurf Creator 2.0.
The XL has a wave shaping face of 9” wide x 14.3” high. It has two 4.75” suction cups in series, 1 in front and 1 behind the wave shaping face. It is 13” long in total and made of marine grade polymer and floats. To attach properly to the boat it requires a flat area that is 5” vertical by 12” long. The XL's suction cups are designed for marine applications and made of rubber and stainless steel with a plastic handle and stainless steel pins, if you don't have space for the XL to attach checkout our SWELL Wakesurf Creator Slim.
When ready to attach the SWELL Wakesurf Creator XL to your boat, make sure the area is clear of any residue (there is often a layer of algae the human eye can’t see), for best results apply the Creator XL while boat is in the water, you will want to push the device into the boat while flipping the suction cup levers (the more pressure towards the boat while pushing the levers the stronger the suction will be). If you decide to tether the device, do no tether it to the boat, tether it to a buoy or something that is easily visible like a spare lifejacket. The force of the boat pulling the creator through the water attached only at the tether will pull through the tether hole.